Datasheet

NXP Semiconductors
AN11211
Blueboard Quick Startup Guide
2.8 Other supported system architectures
The projects described in this guide are also available on Linux. The projects are
preconfigured for the use on the Raspberry Pi with the Raspbian image. The SPI
interface is used for the communication between the application and the NFC controller.
The software and the start guide can be downloaded at the product page of the
EXPLORE-NFC [13]
.
Although this guide only describes the use of the EXPLORE-NFC extension board, it also
supports the PNEV512B and the CLEV663B Blueboards. These Blueboards can be used
with a special adaptor called BluePi. For information about how to configure the
hardware and the software please refer to section 7.8
.
3. Installation of the LPCXpresso Board
The guidelines to install the reader are as follows:
• Connect the LPCXpresso Board as well as the Blueboard to a real USB2.0 port of
the PC (for speed reasons) using the mini-USB connector. The PC detects and
installs the Board automatically. The Blueboard only needs to connected to the PC
out of power reasons.
• Once the Board is installed, open the Device Manager of the PC to check that the
installation has been successful. The item “USB Device with DFU Capabilities” is
being displayed.
Fig 15. Enumeration of the LPCXpresso Board in Device Manager Window
AN11211 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Application note
COMPANY PUBLIC
Rev. 1.9 — 1 December 2014
226219
12 of 36