Datasheet

ADC1010S_SER All information provided in this document is subject to legal disclaimers. © NXP B.V. 2010. All rights reserved.
Product data sheet Rev. 2 — 28 December 2010 7 of 39
NXP Semiconductors
ADC1010S series
Single 10-bit ADC; CMOS or LVDS DDR digital outputs
[1] Typical values measured at V
DDA
=3V, V
DDO
=1.8V, T
amb
=25°C and C
L
= 5 pF; minimum and maximum values are across the full
temperature range T
amb
= −40 °C to +85 °C at V
DDA
=3V, V
DDO
= 1.8 V; V
INP
− V
INM
= −1 dBFS; internal reference mode; applied to
CMOS and LVDS interface; unless otherwise specified.
Digital outputs, CMOS mode: pins D9 to D0, OTR, DAV
Output levels, V
DDO
=3V
V
OL
LOW-level output voltage OGND - 0.2V
DDO
V
V
OH
HIGH-level output voltage 0.8V
DDO
-V
DDO
V
C
O
output capacitance high impedance; OE =HIGH - 3 - pF
Output levels, V
DDO
=1.8V
V
OL
LOW-level output voltage OGND - 0.2V
DDO
V
V
OH
HIGH-level output voltage 0.8V
DDO
-V
DDO
V
Digital outputs, LVDS mode: pins D8_D9_P to D0_D1_P, D8_D9_M to D0_D1_M, DAVP and DAVM
Output levels, V
DDO
= 3 V only, R
L
= 100 Ω
V
O(offset)
output offset voltage output buffer current set to
3.5 mA
-1.2-V
V
O(dif)
differential output voltage output buffer current set to
3.5 mA
-350-mV
C
O
output capacitance - 3 - pF
Analog inputs: pins INP and INM
I
I
input current −5- +5μA
R
i(dif)
differential input resistance - 19.8 - kΩ
C
i(dif)
differential input capacitance - 2.8 - pF
V
I(cm)
common-mode input voltage V
INP
=V
INM
1.1 1.5 2.5 V
B
i
input bandwidth - 650 - MHz
V
I(dif)
differential input voltage peak-to-peak 1 - 2 V
Common mode output voltage: pin VCM
V
O(cm)
common-mode output voltage - V
DDA
/2 - V
I
O(cm)
common-mode output current - 4 - mA
I/O reference voltage: pin VREF
V
VREF
voltage on pin VREF output 0.5 - 1 V
input 0.5 - 1 V
Accuracy
INL integral non-linearity - ±0.07 - LSB
DNL differential non-linearity guaranteed no missing codes −0.06 ±0.04 +0.06 LSB
E
offset
offset error - ±2- mV
E
G
gain error full-scale ±0.5 %
Supply
PSRR power supply rejection ratio 200 mV (p-p) on V
DDA
; f
i
=DC - −54 - dB
Table 6. Static characteristics
[1]
…continued
Symbol Parameter Conditions Min Typ Max Unit