User's Manual

Jennic

JennicJennic

Jennic

1. Introduction

The JN5148-001-Myy module family provides designers with a ready made component which allows IEEE802.15.4

[1] wireless applications, using Jennic’s JenNet networking protocol or ZigBee PRO, to be quickly and easily included

in product designs. The modules integrate all of the RF components required, removing the need to perform

expensive RF design and test. Products can be designed by simply connecting sensors and switches to the module

IO pins. The modules use Jennic’s single chip IEEE802.15.4 Wireless Microcontroller, allowing designers to make

use of the extensive chip development support material. Hence, this range of modules allows designers to bring

wireless applications to market in the minimum time with significantly reduced development effort and cost.

Three variants are available: JN5148-001-M00 (standard module with integral antenna), JN5148-001-M03 (standard

module with uFl connector for use with external antennae) and JN5148-001-M04 (high RF power with uFL connector,

improved sensitivity module for evaluation of extended range applications). All modules will have FCC modular

approvals and be compliant with EU regulations. The variants available are described below.

1.1. Variants

1.2. Regulatory Approvals

All module types will be tested against the requirements of European standard ETS 300 328 v1.7.1 and a Notified

Body statement of opinion for this standard is available on request. The High Power module with M04 suffix will be

approved for use in Europe with reduced output power: +10dBm EIRP is the maximum permitted in Europe.

Additionally, modules with M00, M03 and M04 suffixes will have received FCC “Modular Approvals”, in compliance

with CFR 47 FCC part 15 regulations and in accordance to FCC Public notice DA00-1407. The modules are

approved for use with a number of antennas; refer to section Appendix A.6.1 for details. See Appendix A.6 for details

on the conditions applying to this modular approval. The modular approvals notice and test reports are available on

request.

The high power module variant is classified as ‘mobile’ device pursuant with FCC § 2.1091 and must not be used at a

distance of less than 20 cm (8”) from any person.

In addition, all modules will have Industry Canada RSS210e Issue 7 (June 2007) certification.

Variant Description FCCID

JN5148-001-M00 Standard Power, integrated antenna TYOJN5148M0

JN5148-001-M03 Standard Power, uFl connector TYOJN5148M3

JN5148-001-M04 High Power, uFl connector TYOJN5148M4