User Manual

Jennic
JennicJennic
Jennic
22 JN-DS-JN5139-xxx-Myy 1v5 © Jennic 2009
This device has been designed to operate with the antennas listed above. Antennas not included in this list or having
a gain greater than 18 dBi are strictly prohibited for use with this device. The required antenna impedance is 50ohms.
A.6.2 High Power Module usage limitation
The high power module variants are classified as ‘mobile’ device pursuant with FCC § 2.1091 and must not be used
at a distance of < 20 cm (8”) from any nearby people.
IMPORTANT NOTE: In the event that these conditions can not be met (for certain configurations or co-location with
another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF module in the user manual of the end product.
The user manual for the end product must include the following information in a prominent location;
“To comply with FCC’s RF radiation exposure requirements, the antenna(s) used for this transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.”
A.6.3 FCC End Product Labelling
The final ‘end product’ should be labelled in a visible area with the following:
“Contains TX FCC ID: TYOJN5139M0, TYOJN5139M3 or TYOJN5139M4 ” to reflect the version of the module being
used inside the product.