Owner's manual

12. Cloning NX-RM505

Press the

START

button on both units to begin cloning. It will

take about 40 seconds to complete the cloning and it will flash

‘GOOD’ upon completion of the cloning.

Exit from the Cloning mode by pressing the

MAIN

button and

then exit from the

SETUP

mode by pressing the

MAIN

button

once again.

13. Adjustment of LCD Contrast

Pressing the

MAIN

button and Up on the joystick simultaneously

will make the LCD contrast darker and pressing the

MAIN

button

and

Down

on the joystick simultaneously will make the LCD

contrast brighter.

NX-RM505

NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 44