Owner's manual

8 1

OPERATING INSTRUCTIONS

NX - HDMIX - ET- IR - 120 - 1

HDMI Extender over Ethernet

DEAR CUSTOMER:

Thank you for purchasing this NXG Technology product. For optimum performance and safety,

please read these instructions carefully before connecting, operating or adjusting this product.

Please keep this manual in a safe place for future reference.

FEATURES

• HDCP version 2.0 compliant

• Supports 1080p and 720p video, plus 2-channel audio

• One source can feed up to 125 HDTVs

• Uses off-the-shelf gigabit IP switches for extension and distribution

• Plug-and-play operation - no programming or setup required

• Extends 1080p HDMI signals up to 120m over a single UTP Cat5e/6 cable

• Cable runs can be extended another 120m by adding a Gigabit Ethernet switch

• Uni-cast, multicast or broadcast capable for different applications

• IR source control pass through

• Cascaded a maximum of 3 Ethernet switches

NOTE:

NXG Technology reserves the right to make changes in the hardware, specifications, packaging

and any accompanying documentation without prior written notice.

PAGE 1
OPERATING INSTRUCTIONS NX - HDMIX - ET- IR - 120 - 1 HDMI Extender over Ethernet DEAR CUSTOMER: Thank you for purchasing this NXG Technology product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual in a safe place for future reference. FEATURES • HDCP version 2.
PAGE 2
OPERATING INSTRUCTIONS TABLE OF CONTENTS OPERATING INSTRUCTIONS TYPICAL APPLICATION Specifications Package Contents Maintenance Typical Application Panel Descriptions Connecting and Operating Product Service Warranty SPECIFICATIONS Operating Temperature Range Operating Humidity Range Input Video Signal Input DDC Signal Support Video Format Video Output Transmission Distance Power consumption Dimension (L x W x H) Net Weight -5 to +35° C (+23 to +95° F) 5 to 90%RH (No Condensation) 0.5-1.
PAGE 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS PANEL DESCRIPTIONS TRANSMITTER PANEL RECEIVER PANEL 4 5
PAGE 4
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS CONNECTING AND OPERATING WARRANTY 1) Connect the HDMI™ source to the HDMI™ Transmitter. 2) Connect the CAT6 cable from the Ethernet Transmitter to the Ethernet Receiver. 3) Follow the EIA-TIA 568B standard for all CAT6 RJ45 connections. 4) Connect the HDMI™ Receiver output to the desired HDMI™ input on the display. 5) Connect the power supply into power jack.