Owner’s Manual Model NX-BAS-500 12˝ 500 watt Powered Subwoofer
SAFETY INSTRUCTIONS 1. Read Instructions – Read all the safety and operation instructions before operating the NXBAS-500 (subwoofer). 2. Retain Instructions – Keep the safety and operating instructions for future reference. 3. Heed Warnings – Follow all warnings on the subwoofer and in these operating instructions. 4. Follow Instructions – Follow all operating and other instructions. 5.
B. AMPLIFIER PANEL TOUR Before actual hookup, you should familiarize yourself with the connections on the back of the NX-BAS-500, as shown in Fig.1. 1. VOLUME CONTROL. Rotating this knob clockwise increases the output level of the subwoofer. To start out, make sure that the VOLUME is turned all the way down (fully counterclockwise). Later, after some initial listening tests, you can adjust the volume to your own taste.
C. PLACEMENT Where to position your NX-BAS-500 The NX-BAS-500 operates at low bass frequencies which are essentially omni-directional. That means you can place the NX-BAS-500 almost anywhere in a room without compromising the effectiveness of your main stereo speakers. Four factors need to be considered: 1) distance from your main speakers; 2) distance from a wall outlet; 3) distance from your receiver, amplifier, or flat panel TV; and 4) proximity to walls and corners. 1.
Method A: Line level hookup steps for receivers with subwoofer connections (Refer to Fig. 3 below) Note: This connection method is only for receivers that have a subwoofer or LFE output. You will need one line level RCA to RCA connector cable long enough to reach from your receiver to your NX-BAS500 location. This should be available from your NXG dealer or from radio supply stores. 1. IMPORTANT: Make sure that ALL system components including the NX-BAS-500 are turned OFF before proceeding. 2.
Method B: Line level hookup steps for systems with preamplifier and power amplifier (Refer to Fig. 4 below) 1. IMPORTANT: Make sure that ALL system components including the NX-BAS-500 are turned OFF before proceeding. 2. Locate the LINE output RCA sockets on the back of your preamplifier. These are typically marked PRE, PRE OUT, LINE OUT or TO POWER AMP, depending on the make and model of component. 3.
Method C: Line level hookup steps for flat panel TVs (Refer to Fig. 5 below) 1. IMPORTANT: Make sure that ALL system components including the NX-BAS-500 are turned OFF before proceeding. 2. Connect a set of high-quality line level connection cables (patch cords) between the TV analog audio output connectors and the LINE IN sockets on the back of the NX-BAS-500. Make sure that left is connected to left and right is connected to right. 3. You are now ready to put your NX-BAS-500 subwoofer into use.
Caring for Your NX-BAS-500 The NX-BAS-500 enclosure is finished in a very high-quality polyurethane finish that is both attractive and excellent protection for the wood cabinet. To remove dust, finger prints, and light water marks you can use a soft, dry cloth. Never use a solvent like paint thinner, Ketone, gasoline, MEK, lighter fluid, etc., on the enclosure surface or it will cause permanent damage. F.
