User's Manual

TECHNICAL SPECIFICATIONS
Page 14 of 17
up to 2,500 ft (750m)*
RJ45 ETHERNET INTERF ACE
4-pair Cat5 or betterWire type:
RJ45, auto-crossoverConnectivity:
BNC, RG-59/U or similarConnectivity:
50 to 100ΩImpedance:
Distance:
Green “Link”BNC Interface:
Green “Link”RJ45 Interface:
4 in (100mm) long
1.3 in (33mm) high
1.5 in (38mm) wide
Body:
4.2oz (120g)Transceiver weight:
20.3oz (575g)Total weight:
5.5oz (160g)Power cord weight:
10.6oz (300g)Power supply weight:
14°F to 122°F (-10°C to +50°C)Operating temperature:
20 to 85% non-condensingHumidity:
-22°F to 158°F (-30°C to +70°C)Storage temperature::
Power: Blue “Power On”
OFDM, 128-bit AES encryptionTransmission technology:
up to 328ft (100 m)Distance:
Speed: 10/100 Base
T, half/full duplex, auto-negotiation
Latency: 3mS
auto MDI/MDIX cross-over
Data throughput:
Power output:
COAX BUILDING WIRING INTERF ACE
One control room EoC transceiver plus up to
four remote EoC transceivers are supported
* IMPOR TANT NOTE:
Distance will often be shorter due to power delivery voltage-drop
on the wire. See Maximum Per-Camera Wire Distance Chart on
page 4. Power supplies may be used simultaneously at more
than one EoC Transceiver.
LED S TATUS INDICA TORS
MECHANICAL
ENVIRONMENTA L
POWER CONSUMPTION
Consumption per transceiver: 2.0 W @ 48VDC
Total system consumption: = total consumption of transceivers
+
total consumption of PDs (IP cameras)
+ total power dissipated in the wire
POWER SUPPLY
REGULATOR Y
UL Listed to IEC/UL 60950-1 Complies with FCC part 15B limits
Specifications subject to change without notice.
Technical Specifications
Model NV-EC1701
Ethernet over Coax EoC Transceiver
+ 48VDC
This Power Sourcing Equipment (PSE) supports
Powered Devices (PDs) that are compatible with IEEE
802.3af, or PDs that draw up to 45 watts*. “always
on” 48VDC outputs appear on pins 4&5 and 7&8, and
are current-protected and transient-protected.
Power supplies are external inline, with an IEC380-C14 power inlet
and 6ft (1.8m) line-cord. Input Voltage is 100 ~240VAC 50-60Hz.
A molded P1J 5.5mm barrel connector provides a Class 2 (SELV)
48VDC regulated output. Use only the power cord provided with the
unit or equivalent UL approved type SPT-2, SVT, or SJT, 18/3 AWG
100~240VAC, 1A 60°C Max. 15ft (4.5m) long.
One end with IEC380-C13 appliance
coupler and the other end with NEMA
1015P or equivalent for country.
80 Mbps
±10% useable bandwidth per network
Example: Four megapixel cameras, all sharing one
coax network, each sending 20Mbps video stream(s).