User's Manual

TIPS AND TROUBLESHOOTING

TIPS AND TROUBLESHOOTING
NVIDIA provides an online knowledgebase system with
answers to most common questions available 24x7x365.
You can also use it to submit questions online to our
technical support staff. .
Stereoscopic 3D is not Working
>> Make sure you have activated the hub. Press the green ON/OFF
button on the front of the emitter. The emitter is on when the
button is bright green.
>> Check and make sure that stereoscopic 3D is enabled. Go to the
NVIDIA Control Panel Set Up Stereoscopic 3D screen.
>> Run the Setup Wizard to verify your hardware is operating
properly. Go to the NVIDIA Control Panel (right click on the
desktop). Select Set Up Stereoscopic 3D. Then select Run Setup
Wizard from Test Stereoscopic 3D drop down menu.
>> Ensure your glasses are fully charged.
You can check the battery level of your glasses by pressing
the ON button.
•
If the light next to the button is green, you have up to 40 hours
of battery life remaining. Actual battery life is dependent on the
recharge time.
•
If the light is red, you have less than two hours remaining and it
is recommended that you recharged your glasses.
•
If the light does not turn on, the battery is drained and the
glasses must be recharged.
