User's Manual

INSTALLATION AND SETUP

INSTALLATION AND SETUP
Installing the hardware and software to your computer
system is pretty straightforward. However, there is a
specific order you must follow. The 3D Vision Pro Hub
must be connected AFTER the USB drivers have been
installed.
Note: Before beginning the installation, make sure your
glasses are fully charged. See Charging the Glasses on page 6.
Installation
Connecting the Display
Use the following procedure to install and setup your system for 3D
Vision Pro.
1. Connect your display or projector to your supported
NVIDIA graphics card.
For 3D Vision Ready LCDs use the dual-link DVI cable supplied
with the display.
Note: NVIDIA Quadro graphics boards can support multiple
stereo and non-stereo displays
Note: Make sure to select a display refresh rate of 100Hz or
more from the NVIDIA or OS control panel..
See the following pages for connection diagrams.
