User's Manual

The following connections need to be made on the main board (P1892) as a minimum in order to boot

Jetson TK1 Pro for the first time (assuming the Touch Panel Display is utilized):

Touch Screen Connector (J23): Using the Tyco cable provided, the board needs to be connected to

the display as well.

If the Touch Panel Display will not be utilized a HDMI monitor can be used instead.

RF module

Jetson TK1 Pro comes equipped with a Wi-Fi/BT/GPS module (labeled J6 on Figure 1). The board is

shipped with 3 different antennas that need to be connected to J6. The Communication Module (J6) has

four different connectors as depicted on Figure .

Figure 4: Communication Module (J6) - Antenna Connectors

Antenna (Part Number)

Connects on:

311-0046-000 (2.4GHz

–

Wi-Fi Main / Bluetooth)

311-0045-000 (5GHz

–

Wi-Fi Aux)

311-0047-000 (GPS)

Table 1: Antenna Mapping of Communication Module (J6)

The antennas shall be connected as described on Table 1.