User's Manual

Advance Information – Subject to Change
Provided Under NDA Getting Started – PDK2/3 Only??
12 Getting Started – PDK2/3 Only?? NVIDIA Proprietary and Confidential
I
n
t
e
r
n
a
l
D
r
a
f
t
R
e
v
i
e
w
C
o
p
y
Section 2. Getting Started – PDK2/3 Only??
Note: For instructions on PDK1, refer to...
2.1 Powering up the Board
1. To power up the board, do either of the following:
• Turn on your computer and plug in the supplied USB cable. (The board powers up
on its own.)
• Plug in the supplied DC adapter, turn on the power switch (move SW1 down) and
press the power on/off switch (SW11). For details on the switches, see Table 3 on
page 13.
2. Open the computer’s Device Manager and verify that the Preface PMD is recognized by
the system. The PMD should be listed under Windows SideShow.
The computer may search for and install a driver automatically.
3. Open the SideShow Control Panel and click the Preface PMD icon.
4.
5. Test your connection to the PC by verifying whether the gadgets on the PC are
downloaded to the Preface PMD.
6.
A typical?? display after booting is shown in Figure 5.
Figure 5: Screen Display After Powering Up
Use the baseboard button switches, or the touch-sensitive LCD, to access the various menu
options, as described in Section 2.2 on page 13.