Installation Guide

32 | nVent.com/RAYCHEM
10 HEATING CABLE DAMAGE
• Do not repair damaged heating cable.
Remove entire damaged section and splice in a new length
using the appropriate nVent RAYCHEM splice kits.
• Replace damaged heating cable at once.
Damage allowing moisture and contamination to enter the
heating cable may result in arcing earth faults and potential
fire hazards.
• Heating cable exposed to fire or flame may cause further fire
damage if powered.
Remove from service at once and replace before re-use.
11 TROUBLESHOOTING GUIDE
• Refer to the Troubleshooting guide on pages 36-39.
If the problem persists after following the guide procedures,
contact your nVent representative immediately.