Instruction Manual

4 | nVent.com/RAYCHEM

Tighten the screws

until the metal top

surface is at the

same height as the

inner clear plastic

module.

RayClic-SB-02

Drip

loop

3 4

• Securely tighten the two connection screws, alternating

as they are being tightened.

• Mount flat (wall mounting) bracket under eaves by

installing screws through the center holes.

Do not mount in gutter or where it may be immersed in water.

• Connect heating cable as detailed in steps 3 through 9

(pages 2–4).

• Close the lid and

snap the lever shut.

Do not force lid closed; if

lid does not close, check the

connection to ensure all screws are

fully tightened.

• Tighten the nuts on the heating cable entries

until grommets are compressed.

• Position attachment clips on mounting bracket as shown.

• Attach the

connector to the

mounting bracket

by pressing until it

snaps in place.

• Complete heating

cable installation

and install a drip

loop as shown.

• Protect heating

cable from sharp

edges.

Roof Installation

WARNING: Fire hazard. Loose screws can cause

excessive heating. Be sure screws are fully tightened.