Instruction Manual

nVent.com/RAYCHEM | 3

7 8

• Pull exposed braid back over metal clip.

• Apply a small amout of lubricant to the jacket surface

near the end of the cable.

• Avoid using large amounts of lubricant on the exposed

end of the cable.

• Insert prepared heating cable

end into connector. Push until

heating cable is fully inserted and end is

visible through opening in connection cover

plate.

Note: RayClic connection kits are designed to be installed only

once; the heating cable cannot be removed once installed

IceStop and XL-Trace Edge Only

• Using wire cutters, cut away 1 inch of the braid.

• Pull exposed braid back over metal clip.

• Using wire cutters, cut away aluminum wrap.

HWAT Only