Instruction Manual

2 | nVent.com/RAYCHEM
1
5
Do not cut through
metal braid or
inner jacket.
2
4
• Using the plastic cable ties, attach the bracket to the pipe.
Note: For roof-mounted applications, follow steps 3 through
9 (pages 2–4), then turn to “Roof Installation” on page 4.
Do not install the end seal where it can be immersed in water.
3
• Allow enough extra heating cable to make service loops
as required.
• Make sure end of heating cable is cut clean.
• Remove the outer jacket.
• Place metal clip over the base of exposed braid.
• For the RayClic-LE
lighted end seal, fold
up the four outer snaps, then
position the connector over the snaps
and press down.
• Score around
and down the
outer jacket of the
heating cable 3 1/8 inches
from the end.
If you experience difficulty during installation, refer to the “Troubleshooting Guide” on page 5.
Lighted End Seal Installation