Instruction Manual

8 | nVent.com/RAYCHEM
1
2
Screwdriver slot
Wire hole
Wire
17
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide improved
vibration resistance, reduced maintenance and faster installation.
To connect wires, firmly insert a slotted screwdriver into the square
hole (
1
) to open the spring. When fully inserted, the screwdriver
will lock into place, allowing you to remove your hand and insert the
wire into the round hole (
2
). Remove the screwdriver to clamp the
wire. The wire is held securely against the bus bar for low contact
resistance over time without the need to periodically retighten screws.
• Refer to wiring diagram, step
18A, 18B, or 18C.
• Push screwdriver FIRMLY
into square hole.
• Insert wire into round hole.
• Use green terminal for braid
and ground wires.
• Remove screwdriver.
• Repeat for all connections.