Instruction Manual

6 | nVent.com/RAYCHEM
JBM-SPA
adapter
for small
pipes
Position
adapter
this side
up.
Glass cloth tape
Pipe strap
8
• Fasten stand to pipe. Do not
pinch heating cables.
• Loop and tape extra heating
cable to pipe.
Note: For 1 in (25 mm) and
smaller pipes, use adapter
(purchased separately) and install
between stand and pipe.
5/8 in
(15 mm)
6
• Mark the jacket as
shown.
1 1/4 in
(32 mm)
7
• Pull heating cable back
into stand as shown. Use
cable lubricant if needed.
• Repeat steps 2 through
7 for other heating cables
before continuing to
step 8.
O-ring
9
• Remove box nut.
• Install grommet
plugs in unused
openings.
10
• Place junction box onto
stand. Align key ways
in large box hole with
alignment feature on
stand.
• Put box nut back onto
stand.
• Tighten box nut with
spanner.
Torque = 22 +/- 2 Nm