Instruction Manual

DESCRIPTION
The nVent RAYCHEM FTC-XC Power Connection and End Seal
Kit is for use with nVent RAYCHEM XL-Trace Edge -CR and -CT
heating cables installed in conduit or in direct buried pipe
applications, and for nVent RAYCHEM RaySol floor warming
applications. Materials for one power connection and one end
seal are included in this kit. These installation instructions
must be used in conjunction with the XL-Trace Edge and
RaySol System Installation and Operation Manuals.
For technical support contact your nVent representative or
call nVent at 800-545-6258.
TOOLS REQUIRED
Utility knife Needle nose pliers
Diagonal cutters Heat gun or propane torch
ADDITIONAL MATERIALS REQUIRED (not provided in this kit)
Two UL Listed or CSA Certified junction boxes suitable for
the location, with a clearance hole for 1⁄2 inch conduit or
1⁄2 inch NPT threaded hub. (For RaySol applications, the
power connection end seal may be terminated in a single box,
if desired.)
KIT CONTENTS
Item Qty Description
A 1 Gel-filled end seal
B 2 Black heat-shrinkable tubes (1⁄8 in x 51⁄2 in)
C 1 Green/yellow heat-shrinkable tube (1⁄4 in x 6 in)
D 1 Black heat-shrinkable tube (1⁄2 in x 1 in)
E 1 Cable tie
F 3 Wire nuts
G 2 Warning labels
H 1 RaySol circuit tag
A
B
C
D
F
E
G
H
APPROVALS
FTC-XC
Power Connection and End Seal Kit Installation Instructions
nVent.com/RAYCHEM | 1
718K Pipe Heating Cable, 9J8 6
Radiant Heating Cable
Certified with RaySol heating cable

Summary of content (4 pages)