Installation Manual

12
SECTION
FLOOR
HEATING
SYSTEM
Nuheat Cable
INSTALLATION
Nuheat Cable Installation Guide
INSTALLATION: CABLE & GUIDES
8. Use duct tape, hot glue or a Nuheat Cable Guide to secure the end seal of the
heating cable to the subfloor.
 9. Install“StabilizingCableGuides”pertheInstallation Layout Plan. These
additional“StabilizingCableGuides”willensuretheheatingcablesdoesnot
float during the self-levelling process.
To make installation of the “Stabilizing Cable Guides” easier,
flip the cable guide upside down to smoothly pass underneath
the cable runs. Then flip the guides over to secure them to the
subfloor and snap the cables into place.
Conduct insulation and resistance tests and record the resistance
readings on page 7.
FIGURE 2.28: Secure the end seal
FIGURE 2.29: Install stabilizing guides
2.21 INSTALLING THE CABLE CONT...
!
!