User Manual
Table Of Contents
- Warranty and Return Policy
- RECEIVING THE AIR CONDITIONER
- HANDLING AND TESTING THE AIR CONDITIONER
- HOW TO READ MODEL NUMBERS
- TECHNICAL INFORMATION
- Sequence of Operation
- Heating
- Cooling
- Thermostat
- Remote Access Control (optional)
- Head Pressure Control
- Contactor (115V 12000 BTU/Hr. Units only)
- Contactor (460V Units only)
- Overload (460V Units only)
- Phase Monitor
- 460V to 230V Transformer
- 115V to 10V or 230V to 10V Transformer (optional)
- 115V to 24V or 230V to 24V Transformer and Relay (optional)
- G521216GXXX Generic Schematic (actual unit options may vary)
- G52 All Other Generic 1-Phase Schematic (actual unit options may vary)
- G52 Generic 3-Phase Schematic (actual unit options may vary)
- G521216GXXX Generic Wire Diagram (actual unit options may vary)
- G52 All Other Generic 1-Phase Wire Diagram (actual unit options may vary)
- G52 Generic 3-Phase Wire Diagram (actual unit options may vary)
- INSTALLATION INSTRUCTIONS
- DIMENSIONAL DRAWINGS
- REMOTE ACCESS CONTROL (optional)
- OPERATING PARAMETERS
- ALARM PARAMETERS
- Remote Access Control Pin-out
- Schematic and Wiring Diagram for Remote Access Control
- G52 1-Phase Generic Schematic (actual unit options may vary)
- G52 Generic 3-Phase Schematic (actual unit options may vary)
- G52 Generic Wire Diagram for Remote Access Control (actual unit options may vary)
- G52 Generic 3-Phase Wire Diagram for Remote Access Control (actual unit options may vary)
- DIMENSIONAL DRAWINGS
- INSTALLATION INSTRUCTIONS WITH REMOTE ACCESS CONTROL
- MAINTENANCE
- Refrigerant Properties Chart (R 134a)
- Functional Data
- 8000 BTU/Hr. Unit Characteristics
- 12000 BTU/Hr. Unit Characteristics
- SERVICE DATA
- Components List
- TROUBLE SHOOTING
© 2018 nVent
89101404
- 14 -
REMOTE ACCESS CONTROL (OPTIONAL)
INTRODUCTION
The Remote Access Control is a parametric controller for the complete management of air conditioners. All
settings are pre-programmed at the factory. Cooling/heating set-points, cooling/heating differential and high /low
temperature alarm set-points can be adjusted by the user. Alarms are outputted through a relay contact and also
can be accessed through an Ethernet connection utilizing SNMP, EtherNet/IP and Modbus TCP. A USB connection
is also provided and can be used to interface with the controller utilizing Modbus RTU.
ENERGIZING THE CONTROLLER
The controller is wired and programmed at the factory to be energized when power is supplied to the air
conditioner.
CONTROL STATUS INDICATION
The display has numerous symbols that indicate if the controller is heating, cooling, alarming, if the compressor
is enabled, and if the ambient fan is enabled. The 3 alpha-numeric characters further describe alarms and show
the cabinet temperature by default.
SYMBOL COLOR ICON ON ICON FLASHING
1 AMBER Compressor On Start-up Request
2,3,4 AMBER Not Used Not Used
A AMBER Compressor On Not Used
B AMBER Evaporator Fan On Start-up Request
C AMBER Not Used Not Used
D AMBER Not Used Not Used
E AMBER Heater Active Not Used
F RED Alarm Active Not Used
G AMBER Controller Active Not Used
H AMBER Not Used Not Used