Installation Manual

Rev. B

P/N 23155002

Repainting Homan Standard Paint

Check with the paint manufacturer to insure the paint you are applying is compatible

with the paint on the Homan product.

Homan uses the following TGIC polyester powder coating nishes on standard

catalog items:

1. ANSI 61 Gray

2. RAL 7035

3. White

Refer to homanonline.com for the specic paint nish of the product that you

propose to repaint. When in doubt, consult your local Homan distributor.

IMPORTANT: For best adhesion results, correct surface preparation before

repainting is essential.

PAGE 1
Repainting Hoffman Standard Paint Check with the paint manufacturer to insure the paint you are applying is compatible with the paint on the Hoffman product. Hoffman uses the following TGIC polyester powder coating finishes on standard catalog items: 1. ANSI 61 Gray 2. RAL 7035 3. White Refer to hoffmanonline.com for the specific paint finish of the product that you propose to repaint. When in doubt, consult your local Hoffman distributor.
PAGE 2
GENERAL: All Hoffman TGIC polyester powder coated finishes can be repainted. IMPORTANT: For best refinishing results, always follow the specific instructions provided by your paint manufacturer. 1. Surface Preparation: Generally the following surface preparation can be used. A. Thoroughly sand all enclosure surfaces with 180 grit sandpaper. If sanding marks are objectionable, finish sanding with 220 or 240 grit sandpaper. B. Wet wipe all surfaces with a solvent to remove any possible contaminants. C.