Cut Sheet

Handle Clamp: L160, Sold Separately

Price Key: C

Ease of Use: Preferred

ADDITIONAL PRODUCT DETAILS

For applications such as computer room, tunnel or other low-ventilation areas, specify a smokeless nVent ERICO Cadweld

Exolon mold. Add an XL prefix to the standard mold part number when ordering (for example, a TAC2Q2Q becomes

XLTAC2Q2Q). Similarly, nVent ERICO Cadweld Exolon welding material is also designated by the XL prefix (for example, 150

becomes XL150).

A gap between conductors may be required. See mold tag for more information.

A test weld should be made to check for the possibility of burn through on thin sections and to determine detrimental

metallurgical effects.

W-XX-X-XX-LH-XX-L-M

W* Wear Plates Reduce mechanical abrasion of molds at cable entry points

XX Mold Family

X Price Key

XX Conductor Code

LH Weld End

LH = Weld on left end of conductor

RH = Weld on right end of conductor

(For Mold Families HG, VL, and VN only)

XX Pipe Size

L* Split Crucible Crucible section is split on molds designed with horizontal opening for easier cleaning

M* Mold Only

* Empty if none

WARNING

nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials.

Instruction sheets are available at www.nvent.com and from your nVent customer service representative. Improper

installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause

product malfunction, property damage, serious bodily injury and death and/or void your warranty.