Cut Sheet

MC/AC CABLE TO STUD CLIP, 1/8" MAX FLANGE, 14-2 TO 10-3 MC/AC

CATALOG NUMBER

MAC2

CERTIFICATIONS

FEATURES

Manufactured with stabilizer legs for virtually "wobble-free" support

Snaps into place on metal stud and beam flange

No tools required for installation

Pre-punched holes in clip allow it to be screwed to wood stud, concrete or block

Compliant with NEC® Article 300.4(d), allowing cable to be positioned a minimum of 1-1/4" from face of stud

Compliant with CEC Rule 12-618 for support of MC/AC cable

Factory riveted assemblies are available for installation on flange, purlin, acoustical tee, drop wire, concrete, block or wood

and metal stud

MAC2 snaps in half to accommodate single run of cable effectively making two clips from one

PRODUCT ATTRIBUTES

Material: Spring Steel

Finish: nVent CADDY Armour

PAGE 1
MC/AC CABLE TO STUD CLIP, 1/8" MAX FLANGE, 14-2 TO 10-3 MC/AC CATALOG NUMBER MAC2 CERTIFICATIONS FEATURES Manufactured with stabilizer legs for virtually "wobble-free" support Snaps into place on metal stud and beam flange No tools required for installation Pre-punched holes in clip allow it to be screwed to wood stud, concrete or block Compliant with NEC® Article 300.
PAGE 2
MC/AC Cable Size: 14-2 to 10-3 ADDITIONAL PRODUCT DETAILS Assemblies allow for support from most main and substructures. WARNING nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.nvent.com and from your nVent customer service representative.