Cut Sheet

AF-TI/T ROD TO Z PURLIN CLIP, 1/4" HOLE, THREADED, 1/16"–1/4" FLANGE

CATALOG NUMBER

AF144TI

CERTIFICATIONS

FEATURES

Used to support 1/4" and 3/8" threaded rod from purlin beam flanges 1/16" thru 1/4" thick

Hammer-on or install from the floor with the VAFT tool

Provides method for attaching rod to Z purlin

PRODUCT ATTRIBUTES

Material: Spring Steel

Finish: nVent CADDY Armour

Hole Size: 1/4"

Hole Type: Threaded

Flange Thickness: 1/16" – 1/4"

Static Load: 100 lb

PAGE 1
AF-TI/T ROD TO Z PURLIN CLIP, 1/4" HOLE, THREADED, 1/16"–1/4" FLANGE CATALOG NUMBER AF144TI CERTIFICATIONS FEATURES Used to support 1/4" and 3/8" threaded rod from purlin beam flanges 1/16" thru 1/4" thick Hammer-on or install from the floor with the VAFT tool Provides method for attaching rod to Z purlin PRODUCT ATTRIBUTES Material: Spring Steel Finish: nVent CADDY Armour Hole Size: 1/4" Hole Type: Threaded Flange Thickness: 1/16" – 1/4" Static Load: 100 lb
PAGE 2
DIAGRAMS WARNING nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.nvent.com and from your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty. North America Europe Europe APAC +1.