User's Manual

5
Connecting the Telephone Line
To correct the Main Console to the telephone line, Please follow these steps:
1. Locate the two phone jacks on the back inside of the main console. These phone jacks are
marked “ Phone “ and “ Line “.
2. Connect one end of the telephone cord that came with the system into the connector
labeled Line. Connect the other end of that cord into the wall jack.
3. Connect a telephone to the Main Console through the phone jack.
4. Set the back cover and fix it securely. (Before setting the back cover, you need to finish the Battery
and AC Adaptor installation)
Setting the Antenna
Carefully extend the antenna upward in order to maximize the range of communication
between sensors and the Main console.
Mounting the Main Console
The Main Console may be set on a table top, or mounted on a wall. To mount the console on a wall,
follow these steps.
1. Remove the two black rubber pads and store them away for future use.
2. Measure and fix screws into the wall so that the two screws fit into grooves left under removed
pads.
3. Connect all wire connection to the jacks on the back inside. and replace to back cover.
4. Set the console onto the screws and carefully allow the console to drop into the groove securely
from inside.
About Passwords
This system provides two sets of password for setting the system. A〉”Install ” B〉”Master ”
A〉”Install ” : You can use this password to set the system, such as telephone numbers or record
message… etc
B〉”Master ” : This password is used for setting “ Arm”( Arm away or Arm home) or “Disarm” the system.
When the system is finished installation, your family members only need to “ Arm” or “Disarm” the
system.
Others
We recommend that you install and program the console after installing the other components (sensors)
of the system. This is to ensure that all of the components are working together properly.