User's Manual

15
signal from the PIR Detector.
Check Function
To press CHECK button to check the memory data you have installed previously without any
password, but you can only review not allow to change the data in ‘Check’ Mode. Following with the
menu structure as below.
Check :
0 – T
: To review (1- Exit) Exit time, (2-Alarm) Alarm time, (3- Entry) Entry time.
123456 – P
: To review phone number sets.
7 – MSG
: To review recorded message
8 – DIAL
: To review dial mode.
Speed Dial Function
l Press and hold SP DIAL button and assigned button, Main console will automatically execute
the autodial and alarm, if you want to cancel the autodial and alarm when they are activated,
Please key-in Master password to cancel them or use Remote Control disarm button to stop it.
l SP DIAL + 4 , the autodial order is: phone 4 → phone 1 → phone 2 → phone 3
(Intruder happened condition)
l SP DIAL + 5 , the autodial order is: phone 5 → phone 1 → phone 2 → phone 3
(Fire happened condition)
l SP DIAL + 6 , the autodial order is: phone 6 → phone 1 → phone 2 → phone 3
(Medical help happened condition)
Arm or Disarm Via the Telephone Line (for Tone Mode)
This function allows you to dial your home telephone from outside to Arm or Disarm your security
system. When hear a long ‘Beep’ sounds after 10 rings in the phone, then enter ‘Master code’135246
(default) if the password is correct, it will respond a long Beep sounds in the phone then to respond the
system status at this moment(if the password is less than 6 digits, need to use # button to finish the
password entry). One ‘Beep’ sound means in ‘Armed-Away’, two ‘Beep’ sound means in ‘Armed-Home’
and three ‘Beep’ sound means in ‘Disarm’. At this moment you can key-in (1, 2 or 3 ). Main console will
respond the relative message.
Respond message as below:
l Press 1 means in ‘Armed-Away’ and in the phone will hear one ‘Beep’ sound.
l Press 2 means in ‘Armed-Home’ and in the phone will hear two ‘Beep’ sound .
l Press 3 means in ‘Disarm’ and in the phone will hear three ‘Beep’ sound.
If the system has been programmed in ‘Armed-Away’ or ‘Armed-Home’ status previously, you
need to ‘Disarm’ it first to reset the status. If you do not disarm first, and press ‘1’ or ’2’ directly,
the system will emit ‘bi-bi-bi’ to reject your setting. So press ‘3’ to disarm it.
Check : 0 – T 1 2 3 4 5 6 –
P
7 – MSG 8 – DIAL