Quick Start Guide

9
Federal Communication Commission Statement
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Need Help?
Find answers to common questions, how-to guides, and troubleshooting tips at
www.TabloTV.com/support
.
Or, ask other Tablo users on our community forum at
community.TabloTV.com
.
Or, speak directly with our helpful team of support gurus:
support@Tab
loTV.com
1-844-TABLOTV (822-5688)
Twitter.com/Tab
loSupport
Support hours of operation are Monday–Friday, 9:30 a.m. to 5:30 p.m. ET, excluding Canadian holidays. Messages
received outside of those hours will be returned within 1 business day.
Warranties & Returns
We hope you love your Tablo, but if you’re unhappy for any reason we offer a 30-day return policy on new units
purchased through TabloTV.com. For units purchased through retail partners, the retailer’s return policy applies.
All Tablo units include a 100% repair or replacement warranty for 12 months from the original purchase date.
Tablo’s complete warranty and return policy can be found on our website at
www.TabloTV.com/warranty-returns
.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential install
ation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Industry Canada Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
The distance between user and products should be no less than 20cm
The device is indoor use only
Déclaration d’Industrie Canada
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes
aux RSS (RSS)d'Innovation, Sciences et Développement économique Canada. Le
fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles
susceptibles de provoquer un fonctionnement indésirable de l'appareil.
La distance entre l'utilisateur et de produits ne devrait pas être inférieure à
20cm
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device
The distance between user and products should be no less than 20cm