User Manual

ALM - Move the “*” symbol to the back of ALM, long press the power button to turn it ON/OFF.
(Note: If the measured value exceeds the maximum or minimum value of SPO2 or PR, there will give off
sound when ALM is turned on.)
BEEP - Move the “*” symbol to the back of BEEP, long press the power button to turn it ON/OFF.
(Note: When Beep is turned ON, the sound emitted during the test indicates the pulse rate sound.)
• SPO2 SETTING (Figure 4)
Move the “*” symbol to the back of SPO2 SETTING, press the power button for 1 second going to set the
SPO2 ALM HI, SPO2 ALM LO & +/-. Short press the power button to select the item between SPO2 ALM HI,
SPO2 ALM LO & +/-.
When the * symbol show behind the “+/-”, press direction button for 1 second to change the “+” to “-” or
change the “-” to “+”.
SPO2 ALM HI - Move the “*” symbol to the back of SPO2 ALM HI. With “+” shows on the right side of +/-,
long press the power button each time can increase the value to a higher value (until it reaches to the
highest).
SPO2 ALM LO - Move the “*” symbol to the back of SPO2 ALM LO. With “-” shows on the right side of +/-,
long press the power button each time can reduce the value to a lower value (until it reaches to the
lowest).
• PR SETTING (Figure 5)
Move the “*” symbol to the back of PR SETTING, press the power button for 1 second going to set the PR
ALM HI, PR ALM LO & +/-. Short press the power button to select the item between PR ALM HI, PR ALM
LO & +/-.
When the * symbol show behind the “+/-”, press direction button for 1 second to change the “+” to “-” or
change the “-” to “+”.
PR ALM HI - Move the “*” symbol to the back of PR ALM HI. With “+” shows on the right side of +/-, long
press the power button each time can increase the value to a higher value (until it reaches to the highest).
PR ALM LO - Move the “*” symbol to the back of PR ALM LO. With “-” shows on the right side of +/-, long
press the power button each time can reduce the value to a lower value (until it reaches to the lowest).
6