User Manual

Set Up Your Device

Battery Installation

1. Press the tab on the battery cover at the back of this device, so

as to lift it up and remove.

2. Insert 2 AAA (Included) alkaline batteries according to the +/–

markings.

3. Snap the battery cover on, ensuring it clicks into place. Make

sure that the battery cover is securely in positon.

NOTE: When the low battery symbol appears on screen, turn off this

device and follow the instructions above to replace batteries.

CAUTION

Never leave any low battery in the battery compartment as it may leak and cause damage to this device.

Measurement

Press power button to turn the Pulse Oximeter on.

Put one of fingers into rubber hole of the oximeter (it is best to put

the finger thoroughly) with nail surface upward, then releasing the

clamp.

Note: The oximeter will be automatically powered off when no finger

in the device for longer than 16 seconds.

Setting of Parameter

When the device is under measuring interface, press the power button for 1 second in order to entering

into Menu Setup (Figure 1).

Menu Setup

Under the Menu Setup, user can short press the power button each time moving the “*” symbol to the

back of the SYSTEM SETTINGS, ALM SETTING, SPO2 SETTING or PR SETTING for adjustment.

• SYSTEM SETTINGS (Figure 2)

Move the “*” symbol to the back of SYSTEM SETTINGS, press the power button for 1 second going to set

the MODE, DEMO, BRIGHTNESS & RESTORE. Short press the power button to select the item between

MODE, DEMO, BRIGHTNESS & RESTORE.

MODE - Move the “*” symbol to the back of MODE, long press the power button to select CONTINUOUS

or SINGLE measurement (REMARK: only SINGLE measurement will give audible read out of the readings

for the user after 30 seconds.)

DEMO - Move the “*” symbol to the back of DEMO, long press the power button to turn it ON/OFF.

BRIGHTNESS - When the “*” symbol shows behind “BRIGHTNESS”, long press the power button each time

can change the brightness value from 1 to 5.

RESTORE - When the “*” symbol shows behind “RESTORE”, long press the power button can change to

“OK”, which causes the device to restore factory data setting.

• ALM SETTING (Figure 3)

Move the “*” symbol to the back of ALM SETTING, press the power button for 1 second going to set the

ALM & BEEP. Short press the power button to select the item between ALM & BEEP.