User Manual
Table Of Contents
M
Measurement
(connued)
4. While sing upright in a chair with your feet flat on the floor, press “START/STOP".
Symbols on screen will flash and cuff will begin to inflate. Do not move, acvate arm
muscles, or talk during measurement.
5. Measurement can be stopped at any me by pressing “START/STOP".
6. When a pulse is detected, a heart symbol will flash on screen.
7. When measurement is complete, the cuff deflates automacally and your systolic, diastolic,
and pulse rate will display on screen.
8. Turn off this device by pressing “START/STOP", remove from your arm by detaching hook-
and-loop fasteners. If this device is accidentally le on, it will turn itself off aer two
minutes.
NOTE: This device will remain set on the same user aer you turn it off. To change to the
other user, turn this device off, then press and release “SET” to access user seng. Either
the User 1 or User 2 icon will appear. Press “SET” to switch to the other user icon and press
“START/STOP” to confirm the user and then the device turns off.
U
Using Memory
-
-
R
Recall
This device will store up to 90 measurements each for two users. When more than 90
measurements are taken, the oldest measurement will be replaced.
1. To access Memory-Recall, press and release “MEM” while this device is off.
2. First, it will display the average of your three most recent measurements, indicated on
screen as M AVG (Measurement Average).
3. Press “MEM” again to see the most recent measurement. Press “MEM” repeatedly to
scroll towards the oldest measurement. On screen, M01 indicates the most recent
measurement, with higher M numbers indicang older measurements.
4. If you desire to delete all stored measurements, press and hold “SET” under the Memory-
recall status unl “dEL no” is displayed with “no” flashing. Press and release “SET” to
switch to “dEL YES” with “YES” flashing.
5. Press “START/STOP” with “dEL YES” to confirm clearing the memory and then blank
entry appears on screen, or press “START/STOP” with “dEL no” to go back to the
Memory-recall status without clearing the memory.
6. Press “START/STOP” to exit.