Floor Standing Air Purifier with HEPA & Active Carbon Filter ITEM: FSP-1/0804 INSTRUCTION MANUAL PLEASE READ ALL INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE USE 1
Getting Started Remove the product from the box. Remove any packaging from the product. Please retain all packaging after you have checked and counted all the parts and the contents against the list.
Danger Do not let water or any other liquid or flammable detergent enter the appliance to avoid electric shock and/or a fire hazard. Do not clean the appliance with water, any other liquid, or a (flammable) detergent to avoid electric shock and/or a fire hazard. Do not spray any flammable materials such as insecticides or fragrance around the appliance. Warning Check if the voltage indicated on the appliance corresponds to the local power voltage before you connect the appliance.
Make sure all filters are properly installed before you switch on the appliance. Only use the original Nuvomed filters specially intended for this appliance. Do not use any other filters. Combustion of the filter may cause irreversible human hazard and/or jeopardize other lives. Do not use the filter as fuel or for similar purpose. Avoid knocking against the appliance (the air inlet and outlet in particular) with hard objects.
Description of Parts 1 Display Board 7 Sleep Mode 2 Control Panel 8 Front Panel 3 On/Off 9 Air Purifier Front Case 4 Timer 10 Handle 5 Wind Speed 11 Air Outlet 6 Ionizer 12 Air Purifier Rear Case 5
INSTRUCTIONS FOR USE Installation Step Description Pull the front panel and lift upward. Turn the safety brackets to access filters. Remove both filters. Remove all concealing bags. Place Antimicrobial and HEPA Compound Filters back into the inner side of the product. Note: Please ensure the tab side is facing you. Place Cold Catalyst and Activated Carbon Compound Filters back into the inner side of the produce. Note: Please ensure the tab side is facing you.
Operation 1. Connect the power supply. 2. Set your desired function(s) according to following functional description – Screen display Operation Press the power button to turn on/off the unit. When turning on the unit for function, the digital screen will show the last operating functions used. With every press of the timer button, you can adjust the timer starting from 1 to 12 hours. The air purifier will turn off automatically, after the selected duration has passed.
HEPA Filter replacement Replace the HEPA filter every 6 - 9 months of usage. To buy new HEPA Filter, please visit www.nuvomed.us Cleaning the surface of the housing 1. Turn off the appliance and unplug the unit from power supply. 2. Use a soft cloth to clean the surface of the housing. Troubleshooting Problem Possible Cause Solution Unit does not power The unit is not properly connected to Check if the power cord is correctly on power source. connected to the power source.
a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : - Reorient or relocate the receiving antenna. - Increase the separation between the product and receiver. - Connect the product into an outlet on a circuit different from that to which the receiver is connected.
replacement product will be in warranty for the balance of the 30 days warranty period and an additional one-month period. No charge will be applicable for such repair or replacement. SERVICE AND REPAIR: If service is required for this product, you should first contact Nuvomed Inc. Customer Service at info@nuvomed.us or by calling 1 (866) 815-4714, Monday to Friday 10am to 6pm EST. NOTE: Manufacturer cannot assume responsibility for loss or damage during incoming shipment.
