Installation Sheet

www.satco.comcustomer service 1-800-43-SATCO
2 3
Attach installation bracket to
junction box using two screws
(provided)
Attach base of fixture to
mounting bracket using
two nuts (provided).
Step 1
Step 2
Step 3
L
A
C
E
B
D
1
2
L
N
N
Fixture lead
Twist-on
connector
Supply Wire
Step 4
Align decorative drum with
locking ramps to fixture pins
and twist until it locks into
place.
Step 5
Remove protective film on
diffuser(provided).Tilt the diffuser
and slide into drum. Gently rest it
on bottom of drum.
Enjoy your light!
1. Connect live supply wire (A)
(typically black or the smooth,
unmarked side of the two-
conductor wires) to live f i xture
lead (B) with appropriately sized
twist twist-on connector.
.
2. Connect neutral supply wire (C)
(typically white or the ribbed,
marked side of the two-conductor
wires) t o neutral f ixture lead (D).
3. For positive groundi ng in a 3-wire
electrical system, fasten the fixture
ground (E) (typically cooper or
green plastic coated) to the fixture
mounting strap(1) with the ground
screw (2).
This product is compatible with most residential type dimmers available on the market.
T he dimming performance will depend on kind of dimmer and dimmer settings.
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure
the power is OFF.
The purchased product is covered with a 5 year warranty with respect to any defect in material
or workmanship after purchase date.
Satco shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use, negligence, accident or
exposure to any natural hazard, or excessive use over the limits specified for the unit, or if
any unauthorized alteration or repair was made after purchase.
Dimming
Visit www.satco.com for an up to date list of compatible dimmers.
5 Year limited warranty
• Do not clean with liquids or abrasives.
Cleaning