Installation Sheet

FOR YOUR SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES
YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS
REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL
You don’t need special tools to install this xture. Be sure to follow
the steps in the order given. Under no circumstances should
a xture be hung on house electrical wires, nor should a swag
type xture be installed on a ceiling which contains a radiant type
heating system. Read instructions carefully. If you are unclear as to
how to proceed, consult a qualied electrician.
NOTE: Proper wiring is essential for the safe operation of this
xture.
FIXTURE ASSEMBLY
Carefully remove the xture from the carton and check that all
parts are included as shown in gure. Be careful not to misplace
any of the screws or parts, which are needed to install this xture.
INSTALLATION
IMPORTANT: Do not attach xture directly to outlet box.
Dimmable with ELV and/or LED compatible wall dimmer switches.
STEP 1: Remove decorative cover (G) and hex nut (F). See Figure 1.
STEP 2: Secure mounting plate (B) to outlet box (A) using
mounting screws (C). The side of the mounting plate marked
“GND” must face out.
GROUNDING INSTRUCTIONS
STEP 1: Connect the electrical wires as shown in Figure 2, making
sure that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the xtures ground
wire to it. Otherwise, connect the xture ground wire directly to the
mounting plate (B) using the green screw provided. After wires are
connected, tuck them carefully inside the outlet box.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
FINAL ASSEMBLY
STEP 1: Align the nipple (D) into the xture’s center hole and use
hex nut (F) to secure.
STEP 2: Secure the decorative cover onto the xture.
CLEANING
To clean, wipe xture with a soft cloth. Clean glass with a mild
soap. Do not use abrasive materials such as scouring pads or
powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Be sure to use exact wording from illustration
when ordering parts.
Line art shown may not exactly match the xture enclosed. However,
the installations do apply to this xture.
La ilustración puede no concordar exactamente con la pieza enviada.
Sin embargo, las instalaciones sí aplican para esta pieza.
Les images peuvent ne pas correspondre exactement au luminaire de la
boîte. Par contre, les directives d’installation s’appliquent au luminaire.
INSTALLATION AND SAFETY INSTRUCTIONS
ITEM NO: 62-1451, 62-1452,
62-1453, 62-1454
ARTÍCULO Nº: 62-1451, 62-1452, 62-1453, 62-1454
ARTICLE N°: 62-1451, 62-1452, 62-1453, 62-1454
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper
(Ground)
FIGURE 1.
FIGURE 2.