Installation Sheet

www.satco.comcustomer service 1-800-43-SATCO
This product is compatible with most residential type dimmers available on the market.
T he dimming performance will depend on kind of dimmer and dimmer settings.
• Clean with a soft or damp cloth. While cleaning with the damp cloth make sure
the power is off.
The purchased product is covered with a 5 year warranty in respect of any defect in
material
or workmanship after purchase date.
Satco shall bear no responsibility on account of guarantee, as well as shall bear no
liability for any faults, in case of improper operation, use negligence, accident or
exposure to natural hazard, or excessive use over the limits specifed for the unit, or if
any unauthorized alteration or repair followed.
Dimming
Visit Satco.com for an up to date list of compatible dimmers.
5 Year limited warranty
• Do not clean with liquids or abrasives.
Cleaning
Turn-off /disconnect
power at circuit breaker.
Attach connector
(provided) to AC
cable from junction box:
L side to Black AC wire
N side to White AC wire
Attach the bracket to junction
box using the 2 screws
(provided).
Pull the AC cable with
connector through the bracket
center hole.
Next ’plug’the
two sides of the
orange wire
connector together.
Installed-Congratulations...
Enjoy the light!
Step 2
Step 6
Mounting Bracket Installation
Step 3
Position bracket in place:
Mark mounting hole
positions on ceiling with
reference on bracket.
Drill holes, mount
appropriate anchors, then
secure screws into anchors.
Step 1
Step 5
Wiring
Lock In Place
Lift fixture up against bracket.
Align the arrow sign from
bracket to unlock-sign from
fixture.Slide to locked-sign
to lock fixture in place. Remove
label.
32
A
B
Step 4
Attach ground wire from
fixture to ground wire
from junction box by using
wire nut (provided).