Installation Sheet

ITEM NO: 60-6545

Installation for SEMI-FLUSH:

STEP 1: Carefully unpack the xture, lay out all parts on

a clean surface.

STEP 2: Fasten the mounting strap onto the outlet box

by using provided 2 outlet box screws.

STEP 3: Tie the ground wires from xture and from outlet

box to the ground screw on the mounting strap. Connect

the wire without writing on it (with raised ribs) from the

xture to the white wire (neutral wire) from the supply circuit.

Connect the wire with writing on it from the xture to the

black wire (live wire) from the supply circuit. Cover the

connections using provided wire connectors. Position wires

back inside outlet box.

STEP 4: Connect the nipple into the connector of the

shade, combine with the washer, glass, and body frame,

then secure with the nial.

STEP 5: Place the canopy to the outlet box by aligning the

protruding mounting screws all the way through the canopy

and tighten the xture using lock nuts provided until xture

body is held rmly.

STEP 6: Install the bulbs (not included).

STEP 7: Secure the nipple and washer to the body. Place

the hex nut washer and glass to the nipple and fasten with

the nial.

STEP 8: Turn on the power.

ASSEMBLY AND MOUNTING INSTRUCTIONS

CAUTION:

To reduce the risk of re, use the specied lamp wattage (or smaller) and bulb type identied on the product.

CLEANING INSTRUCTIONS:

Do not use polish or cleaners on your product. Just wipe clean with a soft cloth.

CAUTION – RISK OF FIRE

This product requires installation by a qualied electrician. Before installing be sure to read all instructions

and TURN THE POWER TO THE ELECTRICAL JUNCTION BOX OFF.

ITEM NO: 60-6545

ARTÍCULO Nº: 60-6545

ARTICLE N°: 60-6545

NOTE: The xture can be assembled as SEMI-FLUSH or HANGING PENDANT. If assembling as hanging pendant,

the consumer needs to buy the pendant hardware kits separately.

PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack

and identify all parts prior to building the unit. Each part is identied on the drawing for reference.

DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any

reason. Please repack the unit using the original carton and inserts.

PAGE 1
ITEM NO: 60-6545 ASSEMBLY AND MOUNTING INSTRUCTIONS NOTE: The fixture can be assembled as SEMI-FLUSH or HANGING PENDANT. If assembling as hanging pendant, the consumer needs to buy the pendant hardware kits separately. PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack and identify all parts prior to building the unit. Each part is identified on the drawing for reference. DO NOT DISCARD THE ORIGINAL PACKAGING.
PAGE 2
ESPAÑOL: INSTRUCCIONES DE ENSAMBLAJE Y MONTAJE ARTÍCULO Nº: 60-6545 NOTE: La instalación puede ser montada como SEMIFLUJO o PEDIENTE COLGANTE. Si se monta como pendiente colgante, el consumidor tiene que comprar a parte los kits de ferretería del pendiente. ANTES DE CONTINUAR, LEA DETENIDAMENTE LA HOJA DE INSTRUCCIONES DE ENSAMBLAJE. Desempaque con cuidado e identifique todas las piezas antes de armar la unidad. Cada pieza está identificada en el dibujo de referencia. NO DESECHE EL EMBALAJE ORIGINAL.