Instructions / Assembly

1
INSTALLATION IN OPENING SMALLER THAN 95 ¾”
MEASURE THE EXACT WIDTH OF OPENING
Using the measurement of the opening, calculate
the amount of material to be cut from the
IRON-LATTICE ™ using the following formula:
95 ½
” – (SIZE OF OPENING) – ½” = EXCESS LATTICE
Now take the value of the EXCESS IRON-LATTICE ™
and divide that amount by two (2).
For example: a section is required to fit a 70” opening.
70’’
95 ½” – 70” – ½” = 25”
25” 2 = 12.5”
So in the example, 12.5’’ will have to be taken off each end
Using the tape measure, measure and mark both the upper and
lower rails of the IRON-LATTICE ™ on both ends of the section.
Use the hacksaw to cut the final excess Iron Lattice™ from both ends of the section.
1
2
3
4
1
2
3
4
IMPORTANT NOTE: THE IRON-LATTICE ™ SECTIONS MUST BE SHORTENED BY REMOVING EQUAL AMOUNTS OF MATERIAL FROM BOTH ENDS.
12’’
1/4
1/2
3/4
3
Slide the remaining three (3)
install
ation brackets onto the
IRON-LATTICE ™ se
ction in
the
following locations.
1
2
3
DISCLAIMER: EVERY EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THE INFORMATION CONTAINED IN THESE INSTRUCTIONS.
NU
VO IRON
TM
IS NOT RESPONSIBLE FOR ANY ERRORS OR DISCREPANCIES IN THESE INSTRUCTIONS AND RESERVES THE RIGHT TO MODIFY
AND/OR UPD
ATE THESE INSTRUCTIONS AT ANY TIME.
2
Place one of the installation
brackets against the post,
centered on the width of the
post. Ensure that the 2”marked
line is visible in the center of
both screw holes. Using two (2)
of the screws provided, install
the bracket to the post.
Top Rail
2‘’
Start on the one side
of the opening.
Measure up 2” from
the top rail of the
fence and mark a
pencil line across the
width of the post.
Lift the IRON-LATTICE ™
section up and slide it into
the installation bracket
mounted to the post.
On
ce the IRON-LATTICE ™ is
in the proper position, slide
the installation brackets (on
the other end) over against
the post, center them and
screw into place using four
(4) screws supplied.
Swing the IRON-LATTICE ™
section into position parallel
with the fence. Using the
level, ensure that the section
is level.
Finally, slide the last installa-
tion bracket (on the other
end) over against the post and
screw into place using two (2)
screws supplied
Anti-rust paint should be
applied
to the exposed
metal on the cut ends
to
prevent the bare metal
from corrosion