Nuvo Complete Installation Guide 877- 688-6426 nuvowater.
Welcome Congratulations on your purchase of Nuvo Complete; the NuvoH2O water softener and carbon filter combination! Instead of using salt, NuvoH2O uses a proprietary citrus formulation (CitraCharge) to naturally soften and condition water. First designed for the food services industries in the early 1980’s, these products have been helping to solve complex water problems for some of the nation’s largest businesses.
CAUTION! Please Read All Instructions Before Beginning Installation 1 The Nuvo Complete System MUST be installed vertically. 2 Verify that inflow and outflow lines are properly attached to inlet and outlet ports, as marked on Housing Heads. 3 The brass inserts on the inlet and outlet ports provide stronger threading but can split or break when over-tightened. DO NOT OVERTIGHTEN. 4 The O-ring in the Housing Body must be seated properly. See Basic Installation Steps for your system in this Guide for details.
SYSTEM ASSEMBLY The Nuvo Complete System has been shipped unassembled to insure that the crucial connection between the systems is not damaged. Please be aware that the bracket is specifically designed for the NuvoH2O System housings; it does not allow for additional leeway or “play” in assembly connection. 1 The NuvoH2O Softener and Filter functionality requires the correct flow direction. The Carbon Filter first filters the water and then the water is treated by the softener.
INSTALLATION NuvoH2O Filter Replacement Instructions 1 Before replacing your NuvoH2O filter, we recommend having a towel on hand and placing a bucket underneath your filter system. 2 After turning off the water to the system, press and hold the pressure relief valve at the top of the head to relieve pressure in the filter housing. Note: It is normal for water and air from the filter housing to escape as the pressure is released.
5 Using the screws provided, securely mount the NuvoH2O System horizontally and level (system must hang vertically) to wall studs through top left hole and top right hole of Wall Mounting Bracket. These screws must be securely attached to studs. O-ring must be properly seated on first ridge as shown. FIG. 5 FIG. 4 6 Attach the appropriate fittings (not included) securely into the ports on each side of the Housing Heads.
