User Manual

30
OSD Menu Terms & Settings
6.3 DELAY TIME (05-99)
Thisfunctionisusedtosetthedelaybetweenswitchingofthemodes.Ifthedelayhas
beensetto‘5,’thecamerawillobservedarknessforatleast5secondsbeforeswitching
toNightmode.
6.4 DAYaNIGHT (1-8)
ThisleveldeterminesthethresholdlevelofthedarknessbeforeswitchingfromDay
modetoNightmode.
Note:Theselectablethresholdforthe“NIGHTaDAY”conversionchangesdepending
onthelevelsetforthe“DAYaNIGHT”conversion.(i.e.If“DAYaNIGHT”issetto2,
“NIGHTaDAY”selectablethresholdwouldbeonlyfrom3-9,insteadoffull2-9range)
6.5 NIGHTaDAY (2-9)
ThisleveldeterminesthethresholdlevelofthebrightnessbeforeswitchingfromNight
modetoDaymode.
6.6 IR LED SETUP (Models equipped with IR LEDs only)
ThisfunctionisusedtoadjusttheintensityoftheIRLED.ToomuchIRreectionfroma
subjectcausesover-exposureonthemostfocusedareacausing‘HotSpots’withinthe
picture.Adjustingthissettingcanhelpavoidsuchproblems.