Installation Manual

A. ICR Filter Delay Timer (ICR Switch Time)

This switch is used to delay the automatic ICR cut-ﬁlter.

• ON: The automatic ICR cut-ﬁlter is delayed only by 2~3 seconds.

• OFF: The automatic ICR cut-ﬂlter is delayed by 4~5 seconds.

B. FLK Mode

This function is used to correct ﬂickering of the screen when the camera is operating

under certain ﬂuorescent lighting. Flickering most commonly occurs if the ﬂuorescent light

uses a 50Hz power supply.

• OFF: Select the OFF mode if the ﬂickering is observed.

• ON: Select the ON mode for normal operation (Default).

C. BLC (Back Light Compensation)

This function is used to compensate for exposure problem associated with extremely bright

backgrounds causing the subjects to bloom or silhouette.

• OFF: The Backlight Compensation function is turned OFF.

• ON: Select the ON setting for strong backlit environments.

D. WHITE BALANCE (Automatic White Balance)

This function is used to control the white balance under different lighting conditions. Adjust

this setting to calibrate the camera for correct color rendering. The factory default of

‘ATW’ is recommended for optimal performance.

• ATW (Auto Tracking White Balance): Select the ATW mode, the camera will

continuously monitor changes in the ambient color temperatures and automatically set the

White Balance according to the color temperature.

• AWC (Auto White Balance Control): Select the AWC mode and the camera will calibrate

the White Balance to the most optimal setting to the present lighting condition. This setting

will NOT monitor changes in the ambient color temperatures automatically.

Dip Switch Menu Control Terms