Installation Manual

Dip Switches on the EasyView™ Lite dome cameras are located on the camera

module inside of the Gimbal assembly. To access the Dip Switches, remove the

Gimbal cover temporarily by following the instructions below.

STEP 1

Firmly hold the Gimbal base free of any movement. Press points A & B and pull the

Gimbal cover off from the Gimbal base.

STEP 2

Make the desired Dip Switch adjustments.

STEP 3

Place the Gimbal cover back at the Gimbal base.

Opening the 3-Axis Gimbal Cover

Gimbal Base

Point-A

Point-B

Gimbal Cover

Point A

(Point B on the opposite side)