User manual
21
3
Manual Opeating Test
Under normal functioning, N1 periodically emits a green light signal.
If you turned off the green light signal via the App, we suggest you to
run a weekly test of the proper functioning of your N1.
Press the touch button and N1 will respond with a voice message “No
pollutants detected in the monitored area” and a green light signal will
appear.
Reset
You can reset N1 by easing all settings.
This opeation may be necessay, for example, in case of changes in
your Wi-Fi network (network name and/or password change, modem
replacement) or when moving into a new home or office.
You cannot reset through NUVAP App. To reset and ease all data and
settings of your N1, you must peform the following steps:
• Press and hold down the touch button until N1 will emit a sound and
a blue light signal (about 20 seconds). Then release the button.
• After a few seconds N1 will stat working again, ready for a new
configuation.
• After resetting you must repeat the initial setup
(as detailed in Ch.3 § SETUP - Getting Stated).