Instructions / Assembly

HOSE & REGULATOR ASSEMBLY AND REPLACEMENT
AGCarofnoitcennocedisecnailppaehtgnidulcnirotalugerdnaesohsagPLdradnatsahtiwdeppiuqesemocelbaterfisihT.1
regulator supplied with this fire table must be used. Only a hose
manufacturer can be used for replacement.
detcetedsikaelafisagfowoflehttimilotstcatahtecivedgnitimilwoflcitengamasetaroprocninoitcennoc197oNAGCehT.a
wofleerfsihtterpretnilliwnoitcennoceht,denepogniebevlavecivresrednilycsagPLehtotroirpneposievlavrenrubehtfI.b
c.The connection safety feature will reduce gas flow from the regulator to the
appliance to a minimal level.
d.Be sure that the burner control valve is closed prior to opening the LP gas cylinder service valve to ensure that the
mistakenly.
e.If the connection flow limiting device is triggered mistakenly, close the LP gas
cylinder service valve and the burner valve,
reset, open the cylinder service valve, then open the burner valve and light the
fireplace as per lighting instructions.
.ecafrustohynastcatnocesohehtfitluseryamregnadsuoireS.secafrustohynamorfes
ohehttcetorpoteruseB.2
3.Regular maintenance of the hose and regulator:
a.Inspect the hose before each use of the fire table. If the hose shows signs of
cracks, abrasions, cuts or damage of any
replace the hose as required before using the appliance. For assistance
b.Inspect the seal inside the CGA No 791 service valve on the LP gas cylinder when
replacing the cylinder or at least once
damage, have the seal replaced by a certified gas dealer before operating the
appliance.
.ylnonethgitdnaH.evlavecivresrednilycsagPLehtotnotunnoitcennoc197oNAGCehtnethgitotslootesutonoD.4
sagPLehtotnonoitcennoc197oNAGCehtgninethgitnehwnoitcennocehtnosdaerhtehtssorctonotluferaceB.5
6.“Leak Test” should always be performed after attaching the connection to the LP gas cylinder service valve. (See “Checking
for Leaks” section of this manual on page 11).
7.For the connection of the hose and regulator to the LP tank, refer to the “Connection” section of the LP gas cylinder section
above.
No 791 Cylinder Connection Device. The LP gas hose and
and regulator specified by
between the regulator and the burner valve.
of gas to be a leak.
connection flow limiting device is not triggered
wait 10 seconds to allow the device to
kind, do not operate the appliance. Fix or
with repair or replacement of the hose,[e-mail] . Use only replacement parts from the
manufacturer.
per year. If there is any indication of
cylinder service valve.
7