Instructions / Assembly

ASSEMBLY INSTRUCTIONS

BATTERY

Figure 12

WARNING:

1. Please observe proper polarity and use the correct battery type when installing or replacing the battery. Improper

installation could result in ignition failure.

2. Please remove the battery if consumed or if product is to be left unused for a long period of time.

Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the

control panel to access the battery compartment. The ignitor module requires one AAA size battery, (see Figure 12).

BATTERY IS NOT INCLUDED.

10. Open the door panel (E). Place the gas cylinder into the gas cylinder support (K) and connect the regulator by

turning the black handle clockwise to tighten. To remove the regulator, turn the black handle counter-clockwise.

Secure the gas cylinder by tightening clockwise the retention point found on gas cylinder support (K), (see Figure

10), so that the gas cylinder cannot move from side to side or fall down. The knob on the control panel is turned

all the way to the “OFF” position when the fire pit in NOT in use.

retention point

black handle

Figure 10

Figure 11

11. Once the firepit has cooled completely after use, carefully place the lid (A) onto the fire bowl (see Figure 11).

WARNING: Allow 30 minutes after use for fire pit to cool down before placing the lid to prevent scalding.