Instructions / Assembly

ManualsBrandsNuu Garden ManualsFire Pits44 in. Rectangle Brown Aluminum Propane Gas Wicker Fire Pit Table 50,000 BTU with Fire Glass Stone

CONTENTS

HARDWARE

1 6 4 8 16

J18 J30 J35 L15

Part

Number

Images

and

Sizes

Qty.

HOSE & REGULATOR ASSEMBLY AND REPLACEMENT

AGCarofnoitcennocedisecnailppaehtgnidulcnirotalugerdnaesohsagPLdradnatsahtiwdeppiuqesemocelbaterﬁsihT.1

regulator supplied with this ﬁre table must be used. Only a hose

manufacturer can be used for replacement.

detcetedsikaelafisagfowoﬂehttimilotstcatahtecivedgnitimilwoﬂcitengamasetaroprocninoitcennoc197oNAGCehT.a

woﬂeerfsihtterpretnilliwnoitcennoceht,denepogniebevlavecivresrednilycsagPLehtotroirpneposievlavrenrubehtfI.b

c. The connection safety feature will reduce gas ﬂow from the regulator to the appliance to a minimal level.

d. Be sure that the burner control valve is closed prior to opening the LP gas cylinder service valve to ensure that the

mistakenly.

e. If the connection ﬂow limiting device is triggered mistakenly, close the LP gas cylinder service valve and the burner valve,

reset, open the cylinder service valve, then open the burner valve and light the

ﬁreplace as per lighting instructions.

.ecafrustohynastcatnocesohehtfitluseryamregnadsuoireS.secafrustohynamorfesohehttcetorpoteruseB.2

3. Regular maintenance of the hose and regulator:

a. Inspect the hose before each use of the ﬁre table. If the hose shows signs of cracks, abrasions, cuts or damage of any

replace the hose as required before using the appliance. For assistance

b. Inspect the seal inside the CGA No 791 service valve on the LP gas cylinder when replacing the cylinder or at least once

damage, have the seal replaced by a certiﬁed gas dealer before operating the

appliance.

.ylnonethgitdnaH.evlavecivresrednilycsagPLehtotnotunnoitcennoc197oNAGCehtnethgitotslootesutonoD.4

sagPLehtotnonoitcennoc197oNAGCehtgninethgitnehwnoitcennocehtnosdaerhtehtssorctonotluferaceB.5

6. “Leak Test” should always be performed after attaching the connection to the LP gas cylinder service valve. (See “Checking

for Leaks” section of this manual on page 11).

7. For the connection of the hose and regulator to the LP tank, refer to the “Connection” section of the LP gas cylinder section

above.

:gninraWkcoRavaL

1. Lava rocks may have sharp edges. Wear safety glasses and gloves when handling.

No 791 Cylinder Connection Device. The LP gas hose and

and regulator speciﬁed by

between the regulator and the burner valve.

of gas to be a leak.

connection ﬂow limiting device is not triggered

wait 10 seconds to allow the device to

kind, do not operate the appliance. Fix or

with repair or replacement of the hose,service@nuugarden.com . Use only replacement parts from the

manufacturer.

per year. If there is any indication of

cylinder service valve.

3. Pour the lava media evenly into the burner area (with the exception of the screen-if applicable). The lava should be

1/2-1 inch above the burner.

2. Do not change or substitute the lava rocks provided with this fire pit. If replacing, use only

replacement lava media

available from your local authorized dealer/distributor.

5. Keep away from the unit for the first 20 minutes after igniting your unit for the first time, as lava rocks/pumice stones

could pop out and cause injury. Should any rocks pop out, discard them.

6. Always ensure that lava rocks/pumice stones/glass shards/glass beads are completely dry before use.

cause them to crack or pop.

4. IMPORTANT: Do not exceed a height of 1 inch above the burner when placing lavas media. Ensure no media covers

the igniter screen. Store any excess media in a safe location.

/glass shards/glass beads

Failure to do so will

DO NOT PLACE ANY

MEDIA ON SCREEN

Item Description Qty