NUUGARDEN USA 6366 Corley Road, Norcross GA 30071.
DANGER FIRE OR EXPLOSION HAZARD If you smell gas: WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,personal injury,or loss of life. • Shut off gas supply to the fire table. • Extinguish any open flame.
IMPORTANT SAFETY INFORMATION Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that the control compartment, burners and circulating air passageways of the appliance are kept clean.
CAUTION PROPANE (LP) DANGERS AND WARNINGS LP GAS LP gas is flammable and hazardous if handled improperly. Become aware of the characteristics before using any LP gas product. Propane Characteristics: tles in pools in low areas. n odorant has been added. mproperly. LP GAS WARNINGS: ut of reach of children. htly installed and must not be other enclosed area. ollar or footing. houl propane gas supplier. ards Steering Committee.
CONTENTS HOSE & REGULATOR ASSEMBLY AND REPLACEMENT 1. This fire table comes equipped with a standard LP gas hose and regulator including the appliance side connection for a CGA No 791 Cylinder Connection Device. The LP gas hose and regulator supplied with this fire table must be used. Only a hose and regulator specified by manufacturer can be used for replacement. a.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Note: Please do not tighten any bolt until all bolts have been put into right place. If you tighten one bolt, it maybe cause other bolts out of position. Step 1: Connect 4 side panels (B, C, D, E) by Allen wrench (H0), and tighten with washers(L15) and bolts(J35) . Step 2: Attach the tank base (F) to the side panel(D) and side panel(E) by Allen wrench (H0), and tighten with washers(L15) and bolts(J30) .
OPERATING INSTRUCTIONS (CONTINUED) OPERATING INSTRUCTIONS Installing LP Gas Tank Operating Instructions To operate, you will need one precision-filled standard grill LP gas tank with external valve threads. 20 lb 9 Kg 12.2 in. / 31 cm 17.9 in. / 45.5 cm CAUTION: LP gas tank must be properly disconnected and removed prior to moving this outdoor fireplace. Inserting LP Gas Tank WARNING: Make sure LP gas tank valve is closed. 1. Loosen LP gas tank retainer bolt by turning counter-clockwise. 2.
TROUBLESHOOTING Problem Heating unit won’t light Cause Solution Igniter pin and burner are wet Dry off with a soft cloth Igniter battery is incorrectly inserted Check which direction the battery is inserted Contact us.
