User Manual

www.NutriChefKitchen.com

STRUCTURE AND FUNCTIONS

1. “Stop/Start” button: Press the button for 2 seconds to turn ON/OFF the power

supply; When this key is pressed in the function running, the function running

will be interrupted immediately and the original state will be returned .

2. “Vac” button (with LED): Press this button to vacuum and seal bag

(Select dierent vacuum modes: high=45s, Middle=18s, Low=9s).

You can choose the model according to the food type.

3. “Mode” button: It has three setting mode (high, middle and low). The default

mode is middle, when you press the button, it changes to high mode press this

key again to set to “low”. You can choose the model according to the food type.

4. “Seal” button (with LED): Press this button to seal bag (Vacuuming 6s rst,

Complete sealing according to dierent sealing time setting)

5. “Marinate” (with LED): Press this button to marinate the food by vacuum

cycles. This is particularly useful for marinating and pickling. Allows you to set

the Marinate time in 9 minute cycles, with each cycle consisting of a vacuum/

hold/release process. Each vacuuming step takes approximately one minute

(depending on the Vacuum Level set) and each hold step takes approximately 8

minutes. At the end of each cycle, the vacuum is released. If Sealing has been

activated, the bag will be sealed prior to the release of vacuum in the nal cycle.

6. Up/Down Buttons: These buttons are used to set the seal time. The Up

button increases the displayed value; The Down button decreases the displayed

value;

7. Digital Desplay: Displays the Marinate time, Seal time and Calibration

values as they are input. Time is entered in minutes or seconds, depending on

the function selected. It also displays the ID of a selected preset as well as the

duration or the time remaining in a process as it is being run. It ashes default

values when the process is complete.

COMPONENTS

OPERATING INSTRUCTION

1. Before plugging the unit in, locate the seal bar found in the top foam packaging

insert. Place the seal bar onto the two posts located inside the Vacuum Chamber.

DO NOT remove the non-stick tape covering the seal bar; this is required for

proper operation.

3 6512 4

Vacuum Chamber Lid

Vacuum Chammber

Seal Bar

Bag Clamp

External Vacuum Port

Control Panel

Seal Bar

Posts