PKNESPRESO70 Espresso Machine & Milk Frother Automatic Capsule Espresso Maker with Hot & Cold Milk Frother
PLEASE READ THIS INSTRUCTION MANUAL AND SAFETY INSTRUCTIONS BEFORE OPERATING THE APPLIANCE! Please take time to read these safety precautions carefully before connecting your machine to the power supply. It is essential to follow them and the operating instructions. • First read this entire operating manual. • Danger of electric shock! Never immerse the machine in water or any other liquid. • Connect only to a properly grounded power point.
*In such cases immediately have the machine checked and repaired if necessary at the customer service centre. • The machine location must meet the following requirements: *Choose a dry, stable and level support surface not immediately underneath the power point at least 60 cm away from the washbasin and taps. *Never place on flammable/fusible surfaces or equipment. *Never place the machine or power cable on or nearer than 50 cm to hot surfaces or open flames. *Never cover the machine during operation.
Notes on the Plug This appliance has a grounded 3-prong plug. Connect to a properly grounded outlet only. Do not attempt to modify the plug in any way. Plasticizer Warning CAUTION: To prevent plasticizers from migrating to the finish of the counter top or table top or other furniture, place NON-PLASTIC coasters or place mats between the appliance and the finish of the counter top or table top. Failure to do so may cause the finish to darken; permanent blemishes may occur or stains can appear.
• Do not open the handle when the machine is brewing. • Always pull out the power plug before cleaning the machine. • Only use the machine in a dry room. • Thoroughly rinse out the water tank with fresh water before using for the first time. Clean the Capsule coffee machine using a damp cloth only. Before using for the Milk Froher for the first time 1. Remove all packaging from the Milk Frother and its power base. 2.
HOW TO COMBINE THE COFFEE MACHINE WITH MILK FROTHER 1 2 Put the PKNESPRESO70 on a flat surface. Insert the milk frother base in this hole. 3 4 Use one hand to slant the coffee machine a little and use the other hand to insert the base according to the arrow on the picture 6 www.NutrichefKitchen.
5 6 It shows the base is already connected with the coffee machine Then put the machine on a flat surface. 7 8 Put the milk frother on the base according to the arrow on the picture. Plug the power cord into the electrical outlet, you will hear a beep sound once you put on the milk frother. 7 www.NutrichefKitchen.
Machine Parts and Controls Overview MILK FROTHER 8 www.NutrichefKitchen.
ESPRESSO MACHINE Short espresso button A B Normal espresso button C D Lungo Espresso button E Adjustable dispenser spout (2 positions） D No. name A handle B bu�ons C Dispenser D Drip tray set E wallll F Water tank G water tank (removable) H Power cord I Main switch J Used capsule container K Drip tray cover L drip tray (removable) J K L 9 www.NutrichefKitchen.
ESPRESSO MACHINE Definition of Lighting name status func�on ac�on First use. Refer to “flash out the machine and internal circuit” Light steady/Water tank is empty. Fill up water tank, open handle, then press any b � tto fill th bu�on the iinternal t l circuit. Light steady Stand-by indicator Bu�on light Light in used capsule container Blinking when warming up. light steady ready Each bu�on blinks circularly. In energy saving mode. light steady when handle is open.
USING THE MILK FROTHER Function Whisk option Max capacity (marked with circle) To make cold, frothed milk Time ~80~100s To make hot, frothed milk ~130~180s To heat milk 11 www.NutrichefKitchen.
1. Choose the appropriate whisk and insert it on the whisk head inside the jug. (see the table above for reference). 2. Pour milk into the jug according to the max & min markings. (See the max capacity for each whisk type above for reference), place the jug on power base. Place the lid securely 3. Choose the mode you want to make with the milk. a.
USING THE ESPRESSO MACHINE Fill / Refill Water Tank There are two ways to fill the water tank: Directly into the machine, by using for example a jug, or by removing the water tank. Filling without removing the tank • Raise the water tank lid • Fill the tank up to the “MAX” mark with cold fresh water (the maximum capacity is 0.8 litre), or at least the “Min” mark .
The lights on the control buttons are blinking, blue lights in used-capsule container is lighted in blue which goes off after 1 minute Tips: You can check easier if the used container is full or not when the blue light is ON. The indicator will blink in red for first use, meaning the internal circuit is empty. Please fill up water tank and open the handle. Press any button to start pump, once water is detected entering the internal circuit, the red indicators becomes blue.
Brewing Coffee *Make sure the water tank is in place before brewing. Because there is hot cleaning water come out during heating up. CAUTION HOT WATER RISK OF SCALDING 1. Place an empty cup under the dispenser. For small cups, low down the dispensing spout. 2. Move the handle back completely 3. Insert capsule to fall straight into the compartment correctly. 4. Close the handle firmly to load the capsule . 5. Press the desired coffee button only once 6.
Energy saving mode. The machine enters energy saving model automatically once the machine is idle for 15 minutes. The 3 buttons will flash cyclically in energy saving mode. To access quiet energy saving mode, please press any button, appliance will start warming up with lights blinking, when the buttons are lit steadily, the machine is ready to brew coffee. Espresso Machine Cleaning Emptying the capsule container and drip tray. The capsule container holds around 10 used capsules.
Decalcification Decalcification / Maintenance Drinking water varies according to region. The lime particles in hard drinking water are deposited as residues in the machine and can block the piping and cause damage. To prevent this, be sure to decalcify the machine at the very least after making 300 to 400 cups of coffee or in any case if the output falls significantly or after one or two months. Decalcification must be done correctly to prevent damage. So it is essential to follow these instructions.
4. Fill the water tank with water to maximum level mixed with decalcifying solution, make sure the solution is dissolved completely. 5. Press the small button to run decalcifying water as you brew coffee normally, repeat for several times to run out the entire tank water. 6. Repeat the process to run another tanks of water mixed with decalcifying solution. 7.
Steaming out / Storage / Transport Steaming Out • Prior to long periods of disuse or for storage or transport at temperatures below 41°F, it is essential to steam out the machine. This removes water from the system to prevent internal frost damage. • Turn ON the machine • Empty the water tank and place it in its position. • Put an empty cup under the coffee dispensing spout. • Press “lungo” button to start brewing. • Steaming out now commences.
USER MAINTENANCE INSTRUCTIONS This appliance requires little maintenance. It contains no user serviceable parts. Do not try to fix it by yourself. Refer it to a qualified appliance repair technician if servicing is needed. Care & Cleaning Instructions NOTE: To reduce build-up of milk residues, always empty any residual milk and clean immediately after frothing completed. Never leave liquid in the carafe overnight. 1.
TROUBLESHOOTING MILK FROTHER ISSUES Not be able to start SOLUTIONS Check the power is corresponding to your civil electricity. The jug is placed on its original base, not kettle’s base. Poor quality of milk after frothed. Check if the proper whish is used or not. Make sure adequate cleaning has been implemented after the last use. The dried residual milk may stall the frothing speed. Suggested to use whole or semi-skimmed milk, stored at refrigerator at 6~10 degree.
Water on table -Water tank is leaking. -Drip tray is full of water. -When brewing finished, opened the brewing chamber without drip tray set in place. -Water tank is out of its place when hea�ng up. -Check if the valve on water tank is stuck. - Empty the drip tray. - Make sure the drip tray set is in place. - Make sure the water tank is in place. Capsule droped down directly to used capsule container. -Capsule deformed -Try it again with slight different angle.
Milk Frother Features: • 2-in-1 Milk Frother & Warmer • Choose Your Froth: Creates Hot or Cold Milk Froth! • Simple Electric Plug-in Design • Sleek, Modern Kitchen Style • Quick Heat Ability, Warms in Seconds • Transparent Lid to see the Frothing • LED Indicator Light • Convenient Grip Handle • Double Wall Insulation Container • Stain-Resistant & Easy-to-Clean • Removable Parts for Hassle-Free Clean-Up • Energy Efficient Auto Power-Off Feature • Built-in Safety: Dry Boil Protection What’s in the Box: • Espr
