by SLSPT409 40’’ Fitness Trampoline
www.PyleUSA.com SAFETY INSTRUCTIONS 1. Misuse and abuse of this trampoline is dangerous and can cause serious injuries. 2. All trampoline type exercises must be done with the Fitness Trampoline in the flat position. The angle positions are for use with a medicine ball. 3. All purchasers and all persons using the Fitness Trampoline must become familiar with the manufacturer's recommendations for proper assembly, use and care of the Fitness Trampoline. 4.
www.PyleUSA.com Parts List Nr.
www.PyleUSA.com Before Assembly Check all springs BEFORE assembly. If any spring is not attached or damaged, pls follow below processes to attach or replace the spring. A. Find the open end of the SPRING (#3) and hook this end into the hole on the Rail. B. Swing the SPRING (#3) to face inside of the trampoline. C. Attach the metal loop on the MAT (#2) to the spring hook. Assembly Instruction WARNING 1. Keep children away from the trampoline during assembly. 2.
www.PyleUSA.com STEP 2 Remove the bracket pin from both ends of the trampoline, and place them to the side. PIN PIN C B A D STEP 3 Both persons press rails C and D, and using steady pressure, with hands open and fingers extended, use palm of hands to push rails A and B down until they touch the ground. Make sure that all joints are locked into place.
www.PyleUSA.com STEP 4 Insert the PIN back to the bracket to prevent rails from snapping together when you reach the flat position PIN PIN STEP 5 Remove the covering cap on the threaded connector, and slide the protective padding (#4) over the unfolded frame. Make sure the holes on the underside of the protective padding are positioined exactly over the threaded connector for the feet. Make sure handle brackets are visible.
www.PyleUSA.com STEP 6 Turn the frame upside down. Screw the six feet on to the threaded connectors on the underside of the frame. Turn the trampoline over and place it on its feet. STEP 7 Remove rubber “feet” from bottom of 2 legs, next place tube A over each leg, then replace rubber feet. Rubber feet STEP 8 Connect tube D to top of both C tubes. Use spring button to secure C and D together. You now have a “ top assembly”.
www.PyleUSA.com STEP 9 Lower top assembly into both A tubes until bottom hole in top assembly lines up with hole at top of each A tube. You may have to rotate each A tube for top assembly to fit. Secure top assembly in place with E knob. STEP 10 Secure B knob to bottom of both A tubes.
www.PyleUSA.com STEP 11 To change height of handrail bar, remove E knob, move top assembly to desired height, then screw E knob back in place. There are 4 different height adjustments for the handrail. CARE AND MAINTENANCE Inspect the trampoline before each use and replace any worn, defective or missing parts. The following conditions could represent potential hazards: 1. Missing, improperly positioned, or insecurely attached frame padding. 2.
www.PyleUSA.com WARNING IMPORTANT – PLEASE READ! WARNING – GENERAL SAFETY ADVICE • Please read the instructions before use and retain for future reference. • Ensure the trampoline has been assembled correctly, as per the instructions in the manual. • It is essential that the intended site for this trampoline is completely flat and level. If the ground is un-level this will cause movement in the frame and could cause stress on the joined sections.
