Use and Care Manual

www.NutriChefKitchen.com www.NutriChefKitchen.com
4 5
6. Turn over the pan to touch butter with full bake pan surface and
turn pan up one round pancake will stick on the surface .
7. After use, unplug unit from the electrical outlet and allow it to cool
to room temperature before cleaning.
IMPORTANT NOTICE：
WARNING:
1. After opening the product package, throw the plastic bag into
dustbin immediately to prevent children from playing and choking.
2. Do not immerse the unit into water or any other liquid, to avoid
risk of leakage and short-circuit. Do not plug and use If the unit is
wet!
POWER CORD
If power line is damaged, to avoid danger ask manufacturer or
maintenance department for replacement.
CORRECT PLACEMENT
Place it on at table, do not place near re or re goods.
CORRECT USE
When heating, don’t touch the hot pan to avoid scalding. Do not use
metal or rough materials to avoid damage to the non-stick coating.
Do not wash the unit with water which may cause damage. Use a clean
dry damp cloth.
UNUSUAL CONDITION
When in use, the spare parts may have click sound due to the
temperature change, it is a normal phenomenon. You may notice
smoke and a slight odor when using the unit for the rst time as with
any new appliance, it is also normal.
IMPROVEMENT:
Product may vary slightly from instruction if the product that you
purchase has been improved, but it will not change the performance
and use, feel safe to use.
MAKING METHODS
For the rst time of use, wipe the crepe maker clean with a damp cloth,
and wipe the hot pan surface with a paper towel that was dipped with
edible oil or butter.
1. Mix the our and egg, add water slowly, beat the mixture till smooth
with the whip, make sure the consistency of the batter is similar to
thick cream, and then the batter is ready for use. If you set the batter
for 1 or 2 hours, it will produce better eect.
2. Pour the batter into the plate, connect the crepe maker with power,
the indicator light will ash on, it indicates that the crepe maker
begins to heat, in about 3 minutes of pre-heating the indicator light
would go o, then you can begin to make pancake.
3. Turn the preheated crepe maker over and dip it into the plate to
paste the crepe maker with batter, time should not be too long while
doing this, about 3 seconds also. Remove the crepe maker from the
plate and turn it over quickly putting it upwards on table. In about 20
seconds when the batter change color and rim up warp slightly, the
pancake is ready, then scoop up the rim of the pancake with the slice
and pour it into the dish.
4. You may adopt dierent baking time according to dierent
ingredients or personal preference.
5. To the end when the batter in the plate become too little, the crepe
maker may touch the bottom of the plate, at this moment you may
pour the remaining batter onto the hot pan.